Waiting to get a sway control bar …

The ceiling panel is up. Fan-tastic vent holes cut and trim installed. Thanks to Cay and Craig for the extra pair of hands to help get it in the grooves.

For tank, pump, water heater, etc.

The sky cleared long enough to get on the ladder to try out the new antenna and hardware.  I think its secure enough and the right angle adapter keeps it less than 1.5 inches so it fits in the ceiling space!

Its pretty low profile.

Converter hole cut and installed (needs to be wired still). Plumbing connected in the back, moving forward.

[This post is for you Nick, I owe you dinner/drinks] I applied 5 coats of Plasti-mend with a layer of webbing.  It’s sanded and probably as good as it’s gonna get, which is not even close to an even finish, but there are no cracks!  I’ll paint it next week with similar paint as the other pieces (can’t find the Tubby USA site).  A couple of things I learned:

• I think the product needed to be thinned, it was more like taffy.  You can order the thinner at the same site.
• I sanded off the my failed fiberglass repair on the front surface, but left the repair in the back since it was holding it together.  Since this stuff chemically melds with the ABS plastic, the surface warped in funny ways where the fiberglass was still on in back.  Part of the reason I can’t sand it as even as I would like.

With some paint, it will be fine until I can find a new one.

Thanks to Endwell Rug for the quality service and the installers, Bill and Jamie for getting the Forbo Marmoleum cut, glued, and seam sealed. They did a GREAT job and it looks fantastic. Rosie was a big hit sitting in the Endwell Rug parking lot. It was also fun having her at mom’s in West Corners. Thanks to the neighbors for letting her sit in front of their house (missed photo op, next time…).  I suspect she will occupy that spot many times to come.  Thanks mom for helping to make it happen!

Taken with camera, colors more accurate than ones below…

Phone shots…  nice cut job!